Speedo LED Arrangement...

Click on the picture to make larger. LED orientation is shown with a triangle pointing to the cut-out on the negative side of the LED. Observe correct polarity when soldering.

LED 12 is only used on models with tyre pressure warning. LEDs 2A require and additional resistor (location shown circled) in order to make them work.

No.	Type	OEM Colour	Function
1	PLCC-2	Warm White	Speedometer Numbers
2	PLCC-2	Warm White	LCD Backlight
2a	PLCC-2	-	Additional LCD Backlight
3	PLCC-2	Green	Left Indicator
4	PLCC-2	Green	Right Indicator
5	PLCC-2	Orange	ESP Triangle
6	PLCC-2	Red	Battery
7	PLCC-2	Red	Oil Warning
8	PLCC-2	Red	Water Temperature
9	PLCC-2 Domed	Green	Dipped Headlights
10	PLCC-2 Domed	Orange	Rear Fog
11	PLCC-2 Domed	Blue	Full Beam
12	PLCC-2 Domed	Red	Low Tyre Pressure
13	PLCC-2 Domed	Red	Seatbelt
14	PLCC-2 Domed	Red	Airbag
15	PLCC-2 Domed	Green	ECO
16	PLCC-2 Domed	Orange	Diesel Pre-heat
17	PLCC-2 Domed	Orange	ABS
18	PLCC-2 Domed	Red	Handbrake / Brake Pads

There are additional LEDs under the needle. However, these are non-standard PLCC-2 LEDs and we would recommending leaving them to save realigning the speedo needle.